Popis
MICRO SWISS NOZZLE FOR ULTIMAKER2+
This is RepRap style nozzle, it is made from a 360 brass base material and plated with TwinClad XT coating. TwinClad XT is a nickel composite coating designed for very low friction. It offers one of the lowest coefficient of friction, better then nickel with PTFE co-deposit. This coating is also very hard and abrasion resistant. If you are working with abrasive Carbon Fiber, Stainless Steel, wood filled or any other metal filled filaments, this will greatly improve the life of your nozzle.
*M6 Thread 3mm filament diameter.
Orifice size available: .25mm, .3mm, .4mm, .6mm and .8mm
Fits:
- Olson Block
- Ultimaker 2+
| Brand | Micro Swiss |
| Type | RepRap M6 3mm |
| Material | TwinClad XT plated brass |
| Diameter | 0,60 mm |
| Packaging | 1 |
| Fits for | |
| Olsson Block | |
| Ultimaker 2+ | |
| Ultimaker 2+ Extended | |
| Ultimaker 2 with Olsson block upgrade | |
| Ultimaker 2 Extended with Olsson block upgrade | |
| Ultimaker Original *1 *2 | |
| Ultimaker Original+ *1 *2 | |
| Lulzbot TAZ 3 with hexagon hotend upgrade *2 | |
| Lulzbot TAZ 4 with hexagon hotend upgrade *2 | |
| Lulzbot TAZ 5 | |
| Lulzbot TAZ 6 *2 *3 | |
| 3ntr A2 v2 | |
| 3ntr A4 v3 | |
| Every printer with a E3D V4 3.0mm hotend *2 | |
| Every printer with a E3D V5 3.0mm hotend *2 | |
| Every printer with a E3D V6 3.0mm hotend *2 | |
| *1 = You will need to adjust the fan shroud since the nozzle is shorter than the original nozzle. | |
| *2 = You will need to mount it with the nozzle not placed against the front face of the heater block but against the heat break/isolator tube to create a seal. | |
| *3 = Will require disabling of the automatic bed leveling since the ruby tip is not conductive. |
Micro Swiss Nozzle for Ultimaker2+ 0.6mm
Více z kategorie
Micro Swiss Nozzle for Ultimaker2+ 0.6mm
409 Kč