Phaetus Rapido Hotend 2F Black
Exceptional thermal insulation
To ensure greater wear resistance and thermal insulation, the all-metal heatbreak is RCC coated. This also prevents heat creep and blockages caused by the filament, among other things.
Highly efficient heating unit
A rectangular ceramic heating unit delivers higher performance and reliably heats the hotend to 280 °C in just 39 seconds.
New heating block for high-speed printing
The new design of the heating block has a long heating area to enable high volume flows of up to 36 mm³/s. With these flow rates, high-speed applications are impressive!
Removable temperature sensor
The Rapido Hotend 2F uses a PT1000 temperature sensor suitable for high-temperature printing, which is easy to maintain and replace.
Optimised assembly
The Rapido Hotend 2F uses a new cable tie structure to prevent damage during installation. This optimised assembly simplifies the assembly process and makes it more convenient for the user. The heating element is fixed by a metal dome for quick and cost-effective maintenance.
High filament compatibility
The hotend is compatible with all thermoplastic filaments, including but not limited to typical fibre composite filaments such as PLA, ABS, ASA, PETG, TPU, PC, PP, PA and PLA-CF, ABS-CF, PETG-CF, PA-CF /GF, PC-ABS, PAHT, PVA, PET-CF, PP-GF...
Included:
- 4 x M2.5x8 screws
- 2 x M2.5x5 screws
- 1 x M1.6 titanium screw
- 1 x H1.5 hexagon pin
- 1 x H2.0 hexagon pin
- 1 x H7.0/H10.0 open-end wrench
- 1 x Collet Clip
- 1 x Collet
- 1 x extension cable for the heater
- 1 x extension cable for the temperature sensor
- 3 x cable ties
- 1 x leaf spring
- 1 x silicone grease
Phaetus Rapido Hotend 2F Black