BASF Ultracur3D Resin Cleaner - 5kg

Ultracur3D Resin Cleaner

The Ultracur3D Cleaner removes any uncured photopolymer resin from printed parts and is compatible with a wide variety of resins, incl. most resins of the Ultracur3D portfolio.

Cleaning Procedure

• 1. Immerse the part in an agitated bath of Ultracur3D Cleaner for a maximum of 10 minutes. Typical cleaning time is recommended between 5 to 8 minutes. Some require cleaning below 5 minutes.
• 2. Rinse with 2-propanol for additional 1-3 minutes
• 3. 2-propanol can be blown off with pressured air or parts can be dried at ambient temperature. For accelerated drying heat the part for approximately 10 minutes at 60 °C (140 °F)

Ultracur3D Cleaner is non-harmful, non-flammable at room temperature and can be heated up to 50 °C to increase cleaning efficiency. This cleaner is suitable for industrial part washing and cleaning equipment.

Ultracur3D® Cleaner can normally be used until it contains about 10-20% of resin, or until the cleaning performance is noticeably reduced. After this, it should be disposed according to local regulations.

Material Properties

• Liquid Color: Blue
• pH value: 7 (25 °C)
• Melting Point: > 50 °
• Boiling Point: > 100 °C
• Vapour Pressure: 0.017 hPa (20 °C)
• Density: 1.09 g/cm3 (20 °C)
• Viscosity @ 20 °C: mPa·s (cP) 5

BASF Ultracur3D Resin Cleaner - 5kg